Wildlife by State

Peninsular Leaf-toed Gecko

Phyllodactylus nocticolus

The Peninsular Leaf-toed Gecko (Phyllodactylus nocticolus) is a lizard in the family Phyllodactylidae. USGS maps its range in one of the lower 48 states, California, where it covers 2% of the state. Adults reach up to 2.5 in (63 mm) from snout to vent and can weigh up to 0.2 oz (6.6 g).

Peninsular Leaf-toed Gecko
Photo: Madeleine Claire, CC BY 4.0, via iNaturalist. Resized.

It is active at night. It lives among rocks. It eats mainly other animals.

The USGS habitat model maps it in 13 land-cover types, among them Developed, High Intensity, Developed, Low Intensity and Developed, Medium Intensity. The model places it no higher than 610 m (2,000 ft).

Open-licence records from the lower 48 (144 of them) peak in April and are fewest in August. A typical clutch or litter is about 2.

By size, range and water use in the USGS models, the species most easily taken for it are the Baja California Brush Lizard, the Long-tailed Brush Lizard, the Ornate Tree Lizard and the Desert Night Lizard.

Where the Peninsular Leaf-toed Gecko lives

Mapped range of the Peninsular Leaf-toed Gecko in the lower 48 states. Source: USGS Gap Analysis Project range maps, which do not cover Alaska or Hawaii.
StateShare of stateCountiesOpen recordsPeak month
California 2% 2 of 58 147 April

Share of state is the part of each state inside the range map. Counties counts those with at least a tenth of their area in range. A state link opens that state's full list.

When it is recorded

January: 6JFebruary: 2FMarch: 21MApril: 66AMay: 15MJune: 3JJuly: 4JAugust: 1ASeptember: 7SOctober: 7ONovember: 7NDecember: 5D
Open-licence records by month across the lower 48 (144 records). Counts follow observers as well as animals.

Species it can be taken for

Chosen by rule: the same group, an adult size within 30%, at least one shared state and the same water use in the USGS habitat models. It is a list of candidates, not an identification.

Sources

How each figure is derived is set out on the methods page.