Wildlife by State

Slevin's Bunchgrass Lizard

Sceloporus slevini

The Slevin's Bunchgrass Lizard (Sceloporus slevini) is a lizard in the family Phrynosomatidae. USGS maps its range in 2 of the lower 48 states, most widely in Arizona, where it covers 6% of the state. Adults reach up to 2.8 in (70 mm) from snout to vent and can weigh up to 0.4 oz (12 g).

Slevin's Bunchgrass Lizard
Photo: Allan Harris, CC0, via iNaturalist. Resized.

It is active by day. It lives on the ground. It eats mainly other animals.

The USGS habitat model maps it in 6 land-cover types, among them Apacherian-Chihuahuan Semi-Desert Grassland and Steppe, Madrean Upper Montane Conifer-Oak Forest and Woodland and Madrean Pine-Oak Forest and Woodland. The model places it between 1,220 and 3,350 m (4,000 ft to 11,000 ft) in elevation.

Open-licence records from the lower 48 (213 of them) peak in July and are fewest in January. A typical clutch or litter is about 8.5.

By size, range and water use in the USGS models, the species most easily taken for it are the Round-tailed Horned Lizard, the Striped Plateau Lizard, the Ornate Tree Lizard and the Common Lesser Earless Lizard.

Where the Slevin's Bunchgrass Lizard lives

Mapped range of the Slevin's Bunchgrass Lizard in the lower 48 states. Source: USGS Gap Analysis Project range maps, which do not cover Alaska or Hawaii.
StateShare of stateCountiesOpen recordsPeak month
Arizona 6% 3 of 15 253 July
New Mexico 1% 1 of 33 1

Share of state is the part of each state inside the range map. Counties counts those with at least a tenth of their area in range. A state link opens that state's full list.

When it is recorded

January: 0JFebruary: 0FMarch: 14MApril: 17AMay: 37MJune: 5JJuly: 84JAugust: 26ASeptember: 3SOctober: 1ONovember: 26NDecember: 0D
Open-licence records by month across the lower 48 (213 records). Counts follow observers as well as animals.

Species it can be taken for

Chosen by rule: the same group, an adult size within 30%, at least one shared state and the same water use in the USGS habitat models. It is a list of candidates, not an identification.

Sources

How each figure is derived is set out on the methods page.